5
2013-05-22
fabian althaus
The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.
The most recent revision of the board exposes the 1.0 pinout on rev 3 of the Arduino UNO board.
The Ethernet Shield has a standard RJ-45 connection, with an integrated line transformer and Power over Ethernet enabled.
Arduino Ethernet Shield (Rev3)
http://arduino.cc/de/Main/ArduinoEthernetShield
Arduino
Ethernet
SD-Card
Shield
RJ45
arduino shield
Ethernet Shield (Rev3)
ICSP MISO
5V
ICSP SCK
ICSP MOSI
RESET
GND
D8
PWM D9
ETH CS
PWM D11
SPI/D12
SPI/D13
GND
AREF
A0
A1
A2
A3
A4/SDA
A5/SCL
RX/D0
TX/D1
D2
PWM D3
SDCS
PWM D5
PWM D6
D7
RESET
3V3
5V
GND
GND
VIN
IOREF
N/A
A4/SDA
A5/SCL