Intel Galileo Gen2

5 Mo Apr 9 2014 Fabian Althaus Galileo is a microcontroller board based on the Intel® Quark SoC X1000 Application Processor, a 32-bit Intel Pentium-class system on a chip (datasheet). It’s the first board based on Intel® architecture designed to be hardware and software pin-compatible with Arduino shields designed for the Uno R3. Digital pins 0 to 13 (and the adjacent AREF and GND pins), Analog inputs 0 to 5, the power header, ICSP header, and the UART port pins (0 and 1), are all in the same locations as on the Arduino Uno R3. This is also known as the Arduino 1.0 pinout. Galileo is designed to support shields that operate at either 3.3V or 5V. The core operating voltage of Galileo is 3.3V. However, a jumper on the board enables voltage translation to 5V at the I/O pins. This provides support for 5V Uno shields and is the default behavior. By switching the jumper position, the voltage translation can be disabled to provide 3.3V operation at the I/O pins. Of course, the Galileo board is also software compatible with the Arduino Software Development Environment (IDE), which makes usability and introduction a snap. In addition to Arduino hardware and software compatibility, the Galileo board has several PC industry standard I/O ports and features to expand native usage and capabilities beyond the Arduino shield ecosystem. A full sized mini-PCI Express slot, 100Mb Ethernet port, Micro-SD slot, RS-232 serial port, USB Host port, USB Client port, and 8MByte NOR flash come standard on the board. Visit the FAQ page for further informations. Intel Galileo Gen2 http://arduino.cc/en/ArduinoCertified/IntelGalileo revision 2 x1000 arduino 32 bit pentium intel Quark SoC microcontroller board (intel) Galileo gen2 (simple) A0

A4/SDA

A5/SCL

ICSP MISO

ICSP SCK

ICSP MOSI

RESET

GND

ICSP2 MISO

ICSP2 SCK

ICSP2 MOSI

RESET2

GND

D9 PWM

D10 PWM/SS

D11 PWM/MOSI

D12/MISO

D13/SCK

GND

AREF

A4/SDA

A5/SCL

D0/RX

D1/TX

D3 PWM

D5 PWM

D6 PWM

IOREF

RESET

3V3

GND

VIN

not connected

none

coin-cell positive (+)

coin-cell negative (-)

jtag 2 - tms

jtag 4 - tclk

jtag 6 - tdo

jtag 8 - tdi

jtag 10 - reset

jtag 1 - vcc

jtag 3 - gnd

jtag 5 - gnd

jtag 7 - rtck

jtag 9 - gnd

ioref 1 - 5V

ioref 2

ioref 3 - 3.3V

vin-2 - 5V

vin-1 - vin